Table of Contents
Advertisement
Introduction HS 200UTV/HS 250UTV
4. Selecting the Correct Gear.
■ Gear Shift Lever
CAUTION:
To avoid personal injury:
Avoid changing gears when ascending
or descending a slope.
Before ascending or descending a
slope, shift to the "L" range to control
the vehicle speed.
Operate in reverse at slow speeds to
maintain control.
1.
The gear shift lever can only be shifted
when the vehicle is completely stopped
and the brake pedal is pressed.
2.
To avoid transmission and shift linkage
damage, completely stop the vehicle using
the brake pedal before shifting gears.
3.
Select proper gear depending on the type
of job.
4.
Before exiting the vehicle, shift the gear
shift lever to the "NEUTRAL" position and
set parking brake..
NOTE:
When gear shift lever is hard to engage,
do not force the lever. Set the parking
brake, slightly depress the accelerator
pedal and release it to neutral position,
then shift the lever.
When the lever is hard to disengage, do
not force the lever.
Depress the brake pedal fully, then shift
the lever. Damage may occur with wrong
shifting operation.
AN accident could occur through improper
use of the gear shift lever
IMPORTANT:
5. Release the parking brake and start
slowly.
To release the parking brake, depress the
brake pedal, push release button and push
down on the parking brake lever. Make sure
that indicator in the Instrument panel goes off.
[1] Press in the button [a].
[2] Pull to set in the [b] direction. Push to release in the
(b) direction.
■ Accelerator Pedal
The Accelerator pedal is used to increase the
engine and vehicle speed. Push down on it for
higher speed.
STOPPING
■ STOPPING
1.
Release the Accelerator pedal
2.
Step on the brake pedal.
1-28
Advertisement
Table of Contents
