Table of Contents
Advertisement
Introduction HS 200UTV/HS 250UTV
[1] Battery
1.
To slow charge the battery connect the
battery positive terminal to the charger
positive terminal and the negative to the
negative, then recharge in the standard
fashion.
2.
A boost charge is only for emergencies it
will partially charge the battery as early as
possible.
3.
When exchanging an old battery for a new
one use battery of equal specification
shown in table 1.
Battery type
GTX9BS
◆Direction for storage
1.
When storing the vehicle for a long period,
remove the battery from the vehicle, store
in a dry place out of direct sunlight.
2.
The battery will self-discharge while it is
stored; recharge it once every three
months in hot seasons and once every six
months in cold seasons.
■Adjusting toe-in
Proper toe-in
1.
2.
3.
4.
5.
◆Adjusting procedures
1.
2.
IMPORTANT
■Cleaning Muffler
Volts
12
To avoid personal injury:
1-43
0 to12 mm (0 to 0.47 in)
Park vehicle on flat place.
Turn steering wheel so front wheels are
in the straight ahead position.
Lock the park brake and stop the engine.
Measure distance between tire beads at
rear of tire at hub height.
Front distance should be shorter than
rear distance if not adjust tie rod length.
Loosen the lock nut and turn the tie rod
to adjust the rod length until the proper
toe-in measurement is obtained.
Retighten the lock nut.
Keep the equal length of the left and
right tie-rod.
CAUTION
Before
touching
exhaust system, be absolutely sure
that it has sufficient time to cool!
Always wear safety goggles
facemask.
The particulate matter contained in the
muffler contains chemicals that are
harmful to people, animals and marine
life.
If you are unable to do this work, have
it done by your dealer.
any
part
of
an
and
Advertisement
Table of Contents
