Evacuator Valve - Hisun HS 250UTV Owner's/Operator's Manual

Introduction HS 200UTV/HS 250UTV
■Cleaning air cleaner primary element
1. Remove the air cleaner cover and primary
element.
2. Clean the primary elements.
1） When dry dust adheres to the element blow
compressed air from the inside turning the
element. Pressure of compressed air must
be under 205kpa.
2） When carbon or oil adheres to the element
soak the element in detergent for 15
minutes then wash it several times in water
rinse with clean water and dry it naturally
after element is fully dried inspect inside of
the element with a light and check if it is
damaged or not.
3） Replace the primary element
Once yearly or after every sixth cleaning,
whichever comes first.
[1] First air cleaner
[2] Primary element [3] Cover
IMPORTANT

The air cleaner uses a dry element never
apply oil.

Do not run the engine with filter element
removed.

Be sure to refit the cover with the arrow
(on the rear of cover) upright. If the cover
is improperly fitted the evacuator valve
will not function and dust will adhere to
the element.

◆Evacuator Valve

Open the air cleaner cover once a week
under ordinary conditions –or daily when
used in a dusty place-to get rid of large
particles of dust and dirt.
Check fuel line and fuel filter.
CAUTION
To avoid personal injury:

Be sure to stop the engine and remove
the key when attempting to make the
following checks and changes.

Never fail to check the fuel lines
periodically the fuel lines are subject
to wear and aging fuel may leak out
onto the running engine causing a fire.

The fuel line connections should be
checked annually or every 100service
hours whichever comes first.
1. Park the vehicle on a flat surface and
raise the cargo bed.
2. The fuel line is made of rubber and ages
regardless of service period.
3. If the fuel line and clamps are found to be
damaged or deteriorated replace them.
4. Check fuel filter if it is clogged by debris
or contaminated with water replace it.
1-41