Parking Brake - Hisun HS 250UTV Owner's/Operator's Manual

Introduction HS 200UTV/HS 250UTV
■Cleaning radiator screen
CAUTION
TO avoid personal injury:

Be sure to stop the engine before
removing the screen
1. Park the vehicle on a flat surface,
2. Remove the radiator cover,
3. Detach the screen and remove all foreign
materials,
IMPORTANT
Radiator screen must be cleaned from debris to
prevent engine from overheating.
■Checking brake fluid level
CAUTION
TO avoid personal injury:

Never operate the vehicle if the brake
fluid is below the minimum mark.

Use only DOT3 from a sealed container.
Other types of brake fluid may ruin
synthetic resin or rubber installed in
brake system components and may
cause brake failure.

Avoid contamination of the brake fluid
thoroughly clean before removing the
filler cap. Do not open the brake fluid
reservoir cap
necessary.
Use extreme care when filling the reservoir.
If brake fluid spills on the power steering
hose, wash it off with water immediately, as
brake fluid quickly ruins synthetic resin or
rubber hoses.
unless absolutely
1-38
1. Park the vehicle on a level ground and
open the hood.
2. Check to see that the brake fluid level is
up to the LOWER mark.
If it is below the "LOWER" mark add
3.
brake fluid .
■Checking brake pedal
CAUTION
TO avoid personal injury:

Stop the engine and chock the wheels
before checking brake pedal.
1.Inspect the brake pedal for free play and
smooth operation.
Adjust if incorrect free play is found. (see
checking brake pedal in" EVERY 200 HOURS
in PERIODIC SERVICE section)
[1] Brake pedal
[2] PEDAL STROKE
■Checking parking brake
Pull the parking brake lever to apply the
brakes with the key switch in the "ON"
position and the parking brake indicator
should come on.
To release the brake, push in the button on
the tip of the parking brake lever and tilt the
lever down.