Glass Gobo Orientation - SHOWTEC Indigo 5500 Manual

7. Gently lift up the gobo holder
8. Very carefully take the gobo out of the gobo holder with a pair of pliers.
9. Place the new gobo in the gobo holder. Carefully put the pinchcock back, gently press the
pinchcock a little bit together. Possibly use a pair of pliers to press the pinchcock a little bit together.
10. Put the gobo holder back under the pressing snap and push it back.
11. Replace the maintenance caps and fasten all screws.

Glass Gobo Orientation

Coated glass gobos are inserted with the coating against the rim of the holder (away from the spring).
Textured gobos are inserted with the smooth side against the spring. This provides the best results when
combining rotating gobos.
When an object is held up to the coated side
there is no space between the object and its
reflection. The back edge of the gobo cannot
be seen when looking through the coated
side.
10º and then gently pull out the gobo from its position.
28
When an object is held up to the uncoated
side there is a space between the object and
its reflection. The back edge of the gobo can
be seen when looking through the uncoated
side.
Fig. 9