Cleaning Under The Machine - Hayter CODE613A Operator's Manual

5. Refer to the following table to interpret the LED indicator light on the battery charger.
*Refer to Troubleshooting for more information.
Important: The battery can be left on the charger for short periods between uses. If the battery will not
be used for longer periods, remove the battery from the charger; refer to Storage.

Cleaning under the Machine

Service Interval: Before each use or daily.
For best results, clean the machine soon after you have completed mowing, using the easy-wash port.
1. Move the machine onto a flat paved surface.
2. Shut off the motor and wait for all moving parts to stop before leaving the operating position.
3. Lower the machine to its lowest cutting-height setting. Refer to Adjusting the Cutting Height.
4. Wash out the area under the rear deflector where the clippings go from the underside of the machine
to the grass bag.
5. Attach a garden hose that is connected to a water supply to the easy-wash port. Figure 21.
6. Turn the water on.
7. Start the motor and run it until the clippings no longer come out from under the machine.
8. Shut off the motor.
9. Shut off the water and disconnect the hose from the machine.
10. Start the motor and run it for a few minutes to dry the underside of the machine to prevent it from
rusting.
11. Shut off the motor and allow it to cool before storing the machine in an enclosed area.
Indicator light Indicates
Off No battery pack inserted
Green blinking Battery pack is charging
Green Battery pack is charged
Red Battery pack and/or battery charger is over
or under the appropriate temperature range
Red blinking Battery pack charging fault*
Figure 21
1. Easy-wash port
1
25
EN