Table of Contents
Advertisement
r Fisheye Lens (Model No.: ET-D3LEF70)
1)
Adjust the focus at the center of projected image.
f For the steps to adjust the focus, refer to "Adjusting the focus, zoom, and lens shift" (x page 85).
2)
Loosen the lock screw and turn the periphery focus adjustment ring by hand to adjust the focus in
the periphery of the screen.
3)
Check the focus at the center of the image again and make fine adjustments.
4)
Tighten the lock screw.
f Periphery focus adjustment ring is fixed.
Note
f When the projector is used for the first time or when the projection lens is replaced, confirm that the setting in the [PROJECTOR SETUP]
menu → [LENS] → [LENS TYPE] is appropriate, and then execute the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION].
f The projection distance (THROW.DISTANCE) displayed in the periphery focus adjustment ring is an approximate guide.
Confirming the lens type
When the projector is used for the first time or when the projection lens is replaced, confirm the [LENS TYPE]
setting. Change the setting if the type is different from the projection lens attached to the projector.
1)
Press the <MENU> button.
f The [MAIN MENU] screen is displayed.
2)
Press as to select [PROJECTOR SETUP].
3)
Press the <ENTER> button.
f The [PROJECTOR SETUP] screen is displayed.
4)
Press as to select [LENS].
5)
Press the <ENTER> button.
f The [LENS] screen is displayed, allowing to confirm the current setting in [LENS TYPE].
f To change the setting, proceed to Step 6).
6)
Press as to select [LENS TYPE].
7)
Press the <ENTER> button.
f The [LENS TYPE] screen is displayed.
8)
Press as to select the lens type.
f Select the type of projection lens attached to the projector.
9)
Press the <ENTER> button.
Note
f For details of operation, refer to the [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE] (x page 168).
88 - ENGLISH
Chapter 3 Basic Operations — Projecting
Periphery focus adjustment ring
Lock screw
Advertisement
Table of Contents
