Table of Contents
Advertisement
[BRIGHTNESS CONTROL STATUS] screen display example
When [CONSTANT MODE] is set to [OFF]
The screen shows the status that the brightness control is disabled.
When [CONSTANT MODE] is set to [AUTO], and [LINK] is set to [OFF]
The screen shows the status of the brightness control in one projector.
When [CONSTANT MODE] is set to [AUTO], and [LINK] is set to [GROUP A] through [GROUP D]
The screen shows the status of the brightness control of synchronized projectors (up to eight units), including the
projector being controlled through the on-screen menu.
When [CONSTANT MODE] is set to [PC]
1
Display the name of the projector.
2
Display the synchronized group.
3
Display the IP address of the projector.
4
Display the names and IP addresses of projectors in same group detected over the network.
For IPv6 address, "(IPv6)" is displayed instead of the IP address.
Chapter 4 Settings — [PROJECTOR SETUP] menu
BRIGHTNESS CONTROL STATUS
CONSTANT MODE
PROJECTOR
RETURN
MENU
BRIGHTNESS CONTROL STATUS
LINK
PROJECTOR
RETURN
MENU
BRIGHTNESS CONTROL STATUS
LINK
PROJECTOR
1:
PROJECTOR2
2:
PROJECTOR3
3:
4:
5:
6:
7:
UPDATE
MENU SELECT
BRIGHTNESS CONTROL STATUS
CONSTANT MODE
PROJECTOR
RETURN
MENU
OFF
1
OFF
5
1
6
1
GROUP A
2
3
192. 168. 30. 2
192. 168. 30. 3
192. 168. 30. 4
4
5
7
8
PC
5
1
6
ENGLISH - 187
Advertisement
Table of Contents
