Table of Contents
Advertisement
Chapter 5 Operations — Using the information monitor function
[SHUTTER]
[FREEZE]
[OSD]
[IP ADDRESS(WIRED)]
*1 The representative input is displayed when one image is displayed with multiple input signals.
*2 For IPv6 address, "(IPv6)" is displayed instead of the IP address.
[SETUP] menu
Set the information monitor to the menu operation mode by pressing the <INFO> button on the control panel.
For the operation of the menu, refer to "Basic operation procedure in the menu operation mode" (x page 277).
[PROJECTOR]
Perform the setting and operation regarding the projector.
r [PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1)
Press as to select [SETUP].
2)
Press the <ENTER> button.
f The sub-menu item is displayed.
3)
Press as to select [PROJECTOR].
4)
Press the <ENTER> button.
f The detailed item is displayed.
5)
Press as to select [PROJECTOR ID].
6)
Press the <ENTER> button.
f Setting in [PROJECTOR ID] is displayed.
7)
Press the <ENTER> button.
f Setting can be changed.
8)
Press qw to switch the setting item.
f The items will switch each time you press the button.
[ALL]
[1] - [64]
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [PROJECTOR SETUP] menu → [PROJECTOR ID]
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
f If multiple projectors are set up side by side with IDs set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
f Refer to "Setting ID number of the remote control" (x page 99) for how to set the ID number on the remote control.
r [FIRMWARE UPDATE]
Rewriting of the firmware is possible by using the USB memory.
For details of operation, refer to "Updating the firmware using the USB memory" (x page 297).
r [SAVE LOG]
This function is used by a service person.
278 - ENGLISH
Status of the shutter ([CLOSE]: Shutter function enabled; [OPEN]: Shutter function disabled)
Status of the freeze function ([ON]: Paused; [OFF]: Cleared)
Status of the on-screen display function ([ON]: Display; [OFF]: Hide)
IP address of the wired LAN
*2
Select this item when controlling projectors without specifying an ID number.
Select this item when specifying an ID number to control individual projector.
Advertisement
Table of Contents
