Table of Contents
Advertisement
[NETWORK CONTROL]
Set the controls of the projector via the network.
f To use the network function with the projector, it is necessary to set the password of the administrator account.
(x page 227)
1)
Press as to select [NETWORK CONTROL].
2)
Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3)
Press as to select an item, and press qw to change the setting.
[WEB CONTROL]
[COMMAND CONTROL]
[COMMAND PORT]
[Crestron Connected(TM)]
[AMX D.D.]
4)
Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
5)
Press qw to select [OK], and press the <ENTER> button.
Note
f When a password is not set for the administrator account (when blank), the network function of the projector cannot be used. When using
the web control function or the communication control via LAN (including operation by application software), set a password.
f [Crestron Connected(TM)] cannot be set when the [NETWORK] menu → [WIRED LAN] → [IP VERSION] is set to [IPv6].
[PJLink]
Set the PJLink function which controls and monitors the projector using the PJLink protocol.
f To use the PJLink function with the projector, it is necessary to set the password of the administrator account.
(x page 227)
Note
f When a password is not set for the administrator account (when blank), the network function of the projector cannot be used. When using
the web control function or the communication control via LAN (including operation by application software), set a password.
[PJLink PASSWORD]
Set the security authentication password required to connect to the projector.
1)
Press as to select [PJLink].
2)
Press the <ENTER> button.
f The [PJLink] screen is displayed.
3)
Press as to select [PJLink PASSWORD], and press the <ENTER> button.
f The [PJLink PASSWORD] screen is displayed.
4)
Press as to select [PASSWORD] in [CURRENT], and press the <ENTER> button.
f The [PASSWORD] screen is displayed.
5)
Press asqw to select the text, and press the <ENTER> button to enter the text.
f Enter the current PJLink password.
f The factory default setting of password is blank.
6)
After the password is entered, press asqw to select [OK], and press the <ENTER> button.
f The [PJLink PASSWORD] screen is displayed.
Chapter 4 Settings — [NETWORK] menu
Set to [ON] to control with the web browser.
Set to [ON] to control with the <SERIAL IN>/<SERIAL OUT> terminal control command format
(x page 321). Refer to "Control commands via LAN" (x page 314).
Set the port number used for command control.
Set to [ON] to control with Crestron Connected of Crestron Electronics, Inc.
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through "AMX Device Discovery". For details, visit the
following website of AMX Corporation.
https://www.amx.com/
ENGLISH - 229
Advertisement
Table of Contents
