Table of Contents
Advertisement
Zoom Lens with DC motor, the Fixed-focus Lens
1)
Click [Projector control] → [Detail control] → [LENS] → [CALIBRATION].
f The confirmation screen is displayed.
2)
Click [OK].
f The calibrations for the lens shift and focus are started.
Lens position setting page
Click [Projector control] → [Detail control] → [LENS] → [SET POSITION].
1
[Get]
Acquires the current lens position and displays the acquired
values in the lens position information field.
2
Lens position information field
Enter the lens position (vertical position, horizontal position,
focus position, and zoom position).
Note
f The zoom position is displayed in the lens position information field only in following case.
g When the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20,
ET-D75LE30, ET-D75LE40) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10), or when a
projection lens with the stepping motor is attached.
254 - ENGLISH
Chapter 5 Operations — Using the web control function
1
2
3
4
3
[Back]
Returns to the [LENS] page.
4
[Apply]
Moves to the lens position displayed in the lens position
information field.
Advertisement
Table of Contents
