Setting The Lens Type; Executing The Lens Calibration - Panasonic PT-RZ21К Operating Instructions Manual

Note
f When the projector is used for the first time or when the projection lens is replaced, confirm that the setting in the [PROJECTOR SETUP]
menu → [LENS] → [LENS TYPE] is appropriate, and then execute the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION].
f The projected image size and scale shown on the periphery focus adjustment ring are an approximate guide.

Setting the lens type

When the projector is used for the first time or when the projection lens is replaced, confirm the [LENS TYPE]
setting. Change the setting if the type is different from the projection lens attached to the projector.
1) Press the <MENU> button.
f The [MAIN MENU] screen is displayed.
2) Press as to select [PROJECTOR SETUP].
3) Press the <ENTER> button.
f The [PROJECTOR SETUP] screen is displayed.
4) Press as to select [LENS].
5) Press the <ENTER> button.
f The [LENS] screen is displayed, allowing to confirm the current setting in [LENS TYPE].
f To change the setting, proceed to Step 6).
6) Press as to select [LENS TYPE].
7) Press the <ENTER> button.
f The [LENS TYPE] screen is displayed.
8) Press as to select the lens type.
f Select the type of projection lens attached to the projector.
9) Press the <ENTER> button.
Note
f For details of operation, refer to the [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE] (x page 146).

Executing the lens calibration

Detect the lens adjustment limit value, and perform the calibration in the adjustment range. Execute the lens
calibration after attaching the projection lens.
Zoom Lens with DC motor, the Fixed-focus Lens
This section describes the operating procedure when the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8,
ET-D75LE10, ET-D75LE20, ET-D75LE30, ET-D75LE40, etc.) in which the DC motor has not been replaced
with the stepping motor unit is attached, or when the Fixed-focus Lens (Model No.: ET-D75LE50, ET-D75LE95,
ET-D75LE90, etc.) without the zoom function is attached.
1) Press the <MENU> button.
f The [MAIN MENU] screen is displayed.
2) Press as to select [PROJECTOR SETUP].
3) Press the <ENTER> button.
f The [PROJECTOR SETUP] screen is displayed.
4) Press as to select [LENS].
5) Press the <ENTER> button.
f The [LENS] screen is displayed.
6) Press as to select [LENS CALIBRATION].
7) Press the <ENTER> button.
f The confirmation screen is displayed.
Chapter 3 Basic Operations — Projecting
ENGLISH - 73