Table of Contents
Advertisement
rDo not use cell phone, television, or radio as much as possible close to the projector.
Cell phone, television, or radio is using radio wave with different bandwidth from the projector, so there is no effect
on the wireless LAN communication or the send/receive on these devices. However, noise may occur in the audio
or video due to the radio wave from the projector.
rRadio wave for wireless LAN communication does not go through the reinforcing
bars, metal, or concrete.
The projector can communicate through wall or floor made of wood or glass (excluding the glass with metal mesh
embedded), but it cannot communicate through wall or floor made of reinforcing bars, metal, or concrete.
rDo not use the projector as much as possible in a location where static electricity is
generated.
The communication via wireless LAN or wired LAN may be prone to disruption when the projector is used in a
location where static electricity or noise is generated.
There is a rare case that the LAN connection may not be established due to static electricity or noise, so in such
case, turn off the projector, remove the source of problematic static electricity or noise, and turn the projector back
on.
Slot
This projector is equipped with Intel
Optional Function Board or an interface board or module of other manufacturers supporting Intel
(Intel
SDM-S) or Intel
SDM Large (Intel
®
®
hereinafter) can be installed in the slot. For the devices of other manufacturers that the operation has been
verified with this projector, visit the following website.
https://panasonic.net/cns/projector/
Confirmation of operation for the devices of other manufacturers has been performed with the items set
independently by Panasonic Connect Co., Ltd., and not all the operations are warranted. For operation or
performance problems caused by the devices of other manufacturers, contact the respective manufacturers.
DIGITAL LINK
"DIGITAL LINK" is a technology to transmit the video, audio, Ethernet, and serial control signals using a twisted
pair cable by adding unique functions by Panasonic Connect Co., Ltd. to the HDBaseT
formulated by HDBaseT Alliance.
By installing the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) in the slot on the projector,
connection with the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) or
the peripheral devices by other manufacturers based on the HDBaseT
such as the "XTP transmitter" of Extron Electronics) becomes possible. For the devices of other manufacturers
that the operation has been verified with this projector, visit the following website.
https://panasonic.net/cns/projector/
Confirmation of operation for the devices of other manufacturers has been performed with the items set
independently by Panasonic Connect Co., Ltd., and not all the operations are warranted. For operation or
performance problems caused by the devices of other manufacturers, contact the respective manufacturers. The
projector is not equipped with an audio function so it is not possible to output audio.
Art-Net
"Art-Net" is an Ethernet communication protocol based on the TCP/IP protocol.
By using the DMX controller and the application software, illumination and stage system can be controlled. Art-Net
is made based on DMX512 communication protocol.
Chapter 1 Preparation — Precautions for use
Smart Display Module (Intel
®
SDM-L) specification (collectively referred to as "Function Board"
®
SDM) specification slot.
®
communication standard
TM
standard (twisted-pair-cable transmitters
TM
SDM Small
®
ENGLISH - 23
Advertisement
Table of Contents
