Table of Contents
Advertisement
Performing simplified setting using the external input image
Input any focus adjustment still image from the external device connected to the projector, and set the parameters
for [FOCUS OFFSET BRIGHT] and [FOCUS OFFSET DARK] following the guidance of [SETUP ASSISTANT].
1)
Switch to the input to display the focus adjustment image.
2)
Press as to select [LENS].
3)
Press the <ENTER> button.
f The [LENS] screen is displayed.
4)
Press as to select [ACTIVE FOCUS OPTIMIZER].
5)
Press the <ENTER> button.
f The [ACTIVE FOCUS OPTIMIZER] screen is displayed.
6)
Press as to select [FOCUS OFFSET SETUP].
7)
Press the <ENTER> button.
f The [FOCUS OFFSET SETUP] screen is displayed.
8)
Press as to select [SETUP ASSISTANT].
9)
Press the <ENTER> button.
f If the [PROJECTOR SETUP] menu → [LIGHT OUTPUT] is set to [100.0%], the internal focus test pattern of
signal level approximately 50 % is projected, and the [SETUP ASSISTANT] screen (page 1/8) is displayed.
Proceed to Step 11).
f If the [PROJECTOR SETUP] menu → [LIGHT OUTPUT] is set to less than [100.0%], the confirmation
screen is displayed. Proceed to Step 10).
10) Press qw to select [NEXT], and press the <ENTER> button.
f Even if [PROJECTOR SETUP] menu → [LIGHT OUTPUT] is set to less than [100.0%], the projector will
operate with the [100.0%] setting while [SETUP ASSISTANT] is executing. Once [SETUP ASSISTANT] is
completed, it will return to the original [LIGHT OUTPUT] setting value.
f After confirming the confirmation message, press qw to select [NEXT], and press the <ENTER>
button. The internal focus test pattern of signal level approximately 50 % is projected, and the [SETUP
ASSISTANT] screen (page 1/8) is displayed.
f To cancel the setting by [SETUP ASSISTANT], press qw to select [CANCEL], and press the <ENTER>
button. [SETUP ASSISTANT] is canceled, and the [FOCUS OFFSET SETUP] screen is displayed.
11) Wait until [Waiting time] turns [0s].
f Wait until the focus is stabilized.
f When the [Waiting time] turns [0s], the [Please wait...] message disappears, and [NEXT] becomes
selectable.
12) Press qw to select [NEXT], and press the <ENTER> button.
f The [SETUP ASSISTANT] screen (page 2/8) is displayed.
f It will return to previous screen by selecting [BACK] and pressing the <ENTER> button.
13) Press asqw to select [FOCUS POSITION].
14) Press the qw button to adjust the focus.
15) Press asqw to select [NEXT], and press the <ENTER> button.
f The [SETUP ASSISTANT] screen (page 3/8) is displayed.
16) Press asqw to select [TEST PATTERN].
17) Press qw to select [EXTERNAL].
f The items will switch each time you press the button.
[INTERNAL]
[EXTERNAL]
176 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select this item when using the internal test pattern for focus adjustment.
Uses the input image from the external device for focus adjustment. If the level of [Brightness of the
image] falls below the specified value, [NEXT] cannot be selected. When the bright image with a
brightness level indicated in the menu screen (OSD) or greater is input, [NEXT] can be selected.
Advertisement
Table of Contents
