Table of Contents
Advertisement
10) Set [LIGHT OUTPUT] of all projectors to 100 % or the maximum value that can be set.
f Depending on the [OPERATING MODE] settings, [LIGHT OUTPUT] may not be able to be set to 100 %.
11) Set [LIGHT OUTPUT] of the projector with the least brightness to 90 % or 10 % lower than the
maximum value that can be set.
12) Adjust [LIGHT OUTPUT] of each projector.
f Adjust [LIGHT OUTPUT] of all the other projectors so that the brightness will be the same as the projector
with the least brightness.
13) Set [CONSTANT MODE] of [BRIGHTNESS CONTROL SETUP] to [AUTO], and [LINK] to [GROUP A] in
all projectors.
14) Select [APPLY] of [BRIGHTNESS CONTROL SETUP] and press the <ENTER> button in all projectors.
f Automatic correction by the brightness control function starts.
Note
f Automatic correction is performed whenever the light source lights up by switching on/off the projector, etc.
f When the variation in brightness or color has increased due to aging of the light source, or when the light source is replaced, reset
[BRIGHTNESS CONTROL SETUP].
[STANDBY MODE]
Set the power consumption during standby.
1)
Press as to select [STANDBY MODE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[ECO]
Note
f When [ECO] is set, the network function, the <SERIAL OUT> terminal, and some RS-232C commands become inoperable during standby.
When [NORMAL] is set, the network function and the <SERIAL OUT> terminal can be used during standby.
f When [ECO] is set, it may take approximately 10 seconds longer before the projector starts projecting after the power is turned on,
compared with when [NORMAL] is set.
f When [NORMAL] is set, power can be supplied using the <DC OUT> terminal even if the projector is in standby mode. If [ECO] is set, power
cannot be supplied in standby mode.
[POWER MANAGEMENT]
Set the function to save power consumption when there is no input signal.
[NO SIGNAL LIGHTS-OUT]
This is a function to automatically turn off the light source of the projector when there is no input signal for specific
period. The time until the light source is turned off can be set.
1)
Press as to select [POWER MANAGEMENT].
2)
Press the <ENTER> button.
f The [POWER MANAGEMENT] screen is displayed.
3)
Press as to select [NO SIGNAL LIGHTS-OUT].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[10SEC.] - [5MIN.]
Note
f The [NO SIGNAL LIGHTS-OUT] setting item is common with the following menu item.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select this item when using the network function during standby.
Select this item to reduce power consumption during standby.
Disables the no signal lights-out function.
Turns off the light source when there is no input signal for the preset period.
Select [10SEC.], [20SEC.], [30SEC.], [1MIN.], [2MIN.], [3MIN.], or [5MIN.].
ENGLISH - 189
Advertisement
Table of Contents
