[Network Control]; [Memory Viewer] - Panasonic PT-VMZ40 Operating Instructions Manual

2) Press the <ENTER> button.
f The [PROJECTOR NAME CHANGE] screen is displayed.
3) Select characters with the asqw buttons and press the <ENTER> button to enter the projector
name.
f You can enter up to eight characters.
4) After entering the projector name, press as to select [OK] and press the <ENTER> button.
Note
f The factory default setting of the projector name is "Namexxxx". xxxx is a fixed value assigned to each projector.

[NETWORK CONTROL]

Set up the control method of the network.
1) Press as to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3) Press as to select an item and press qw to change the setting.
[WEB CONTROL]
[PJLink CONTROL]
[PJLink NOTIFICATION]
[COMMAND CONTROL]
[COMMAND PORT]
[Crestron Connected(TM)]
[AMX D. D.]
[EXTRON XTP]
4) Press as to select [OK] and press the <ENTER> button.

[MEMORY VIEWER]

Set the operations of the Memory Viewer function.
Note
f The [MEMORY VIEWER] menu can be operated and set only when MEMORY VIEWER input is selected.
f For details on how to use the memory viewer function, please refer to "Projecting with MEMORY VIEWER input" (x page 101).
[SET SLIDE]
Start the slideshow. For details on the slideshow, see "Executing the slide" (x page 102).
[SLIDE TRANSITION EFFECT]
Sets the transition effects when switching the slides playback.
1) Press as to select [SLIDE TRANSITION EFFECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[SLIDE RIGHT]
Chapter 4 Settings - [NETWORK] menu
Set to [ON] to control with the web browser.
Set to [ON] to control with the PJLink protocol.
Set to [ON] to use the PJLink notification function.
f The [PJLink NOTIFICATION] screen is displayed when set to [ON] and the <ENTER> button is
pressed. Set the IP address of the computer to notify the status of the projector in [NOTIFIED IP
ADDRESS 1], [NOTIFIED IP ADDRESS 2].
Set to [ON] to control with the <SERIAL IN> terminal control command format (x page 138). Refer
to "Control commands via LAN" (x page 135).
Set the port number used for command control.
Set to [ON] to control with Crestron Connected of Crestron Electronics, Inc.
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through "AMX Device Discovery". For details, visit the
website of AMX Corporation.
URL http://www.amx.com/
Set to [ON] when connecting the "XTP transmitter" of Extron Electronics to the <DIGITAL LINK/LAN>
terminal.
The [EXTRON XTP] setting must be set to [OFF] when connecting the optional DIGITAL LINK output
supported device (Model No.: ET-YFB100G, ET-YFB200G).
For details of the "XTP transmitter", visit the website of Extron Electronics.
URL http://www.extron.com/
The slides switch from left to right.
ENGLISH - 97