Direct On; Standby Mode; P-Timer; Off - Panasonic PT-TW230EA Operating Instructions Manual

Direct on

1 ) Press ▲▼ to select [Direct on] and
then press the <ENTER> button.
2 ) Press ▲▼ to switch between On and

Off.

When this function is set to [On], the projector
z
will be automatically turned on just by
connecting the AC power cord to a wall outlet.
Be sure to turn off the projector properly. If the
z
projector is turned off in the incorrect sequence,
the Direct On function does not work properly.

Standby mode

This function can set the electric power when the
projector is standing by.
1 ) Press ▲▼ to select [Standby mode]
and then press the <ENTER> button.
2 ) Press ▲▼ to switch between the items
as below.
Restricts some functions in

Eco

standby mode to reduce power
consumption.
Does not restrict functionality
Network
even in standby mode.
Note
When selecting [Network], the cooling fans may be
z
running depending on the temperature inside the
projector even if the projector is turned off.
Refer to "Operating Instructions - Network Operations
z
If Standby mode is set to [Eco], you cannot use network
z
functions when the projector is standing by. Also, you
cannot use some RS-232C protocol commands.
If set to [Network], you can use network functions when
z
the projector is standing by.

P-timer

This function allows you to change the setting of the
P-timer and execute it.
1 ) Press ▲▼ to select [P-timer].
2 ) Press ► or <ENTER> button to access
the submenu.
Mode
J
1 ) Press ▲▼ button to select one mode
among the items as below.

Count up

Count down
Timer
J
1 ) Press ▲▼ to select [Timer] and then
press the <ENTER> button.
2 ) Press▲▼ to set the [Timer](1-180 Min).
Timer is available in [Count down] only. Factory
z
default value is 10 Min.
Execute
J
1 ) Press ▲▼ to select one among the
items as below and then press the
<ENTER> button.
Start
Reset
Exit
*1 : Press the <ENTER> button at Start and the
indication changes into Stop. To stop Count up or
Count down, press the <ENTER> button at Stop
on the screen menu, then the indication changes
into Restart. Press the <ENTER> button at
Restart to resume Count up or Count down.
*2 : Press the <ENTER> button at Reset to return to
the following value:
Count up
".
Count down
Attention
To stop the [P-timer] function, press the <P-TIMER>
z
button.
To cancel the [P-timer], press and hold the <P-TIMER>
z
button for a few seconds.
Setting
The P-timer display 000:00
appears on the screen and the
count up starts. (000:00-180:00)
The time set in the Timer setting
appears on the screen and the
countdown starts.
It executes the count up or count
down function.*
1
Reset the P-timer values.*
To exit the P-timer operation.
"000:00"
Timer that you set
ENGLISH -
2
53