Iq7A-72-2-Us Microinverter Specifications - enphase IQ7 Installation And Operation Manual

Topic
Approved for wet locations
Pollution degree
Communication
Standard warranty term
Compliance
Grounding
Monitoring
Integrated DC disconnect/
Integrated AC disconnect

5.2.4 IQ7A-72-2-US Microinverter specifications

Topic
Commonly used module pairings
Peak power tracking voltage
Operating range
Maximum DC input voltage
Minimum/Maximum start voltage
Maximum DC input short circuit current (module Isc)
Overvoltage class DC port
DC Port backfeed under single fault
PV array configuration
10 No enforced DC/AC ratio. See the compatibility calculator at
compatibility
39
IQ7/IQ7+/IQ7X/IQ7A Microinverters Installation and Operation Manual
IQ7X-96-2-US Microinverter parameters
Unit
Yes
PD3
Power line communication (PLC)
enphase.com/warranty
CA Rule 21 (UL 1741-SA) UL 62109-1, UL1741/IEEE1547, FCC Part 15
Class B, ICES-0003 Class B, CAN/CSA-C22.2 NO. 107.1-01
This product is UL Listed as PV Rapid Shut Down Equipment and
conforms with NEC-2014 and NEC-2017 section 690.12 and C22.1-
2015 Rule 64-218 Rapid Shutdown of PV Systems for the AC and DC
conductors when installed according to manufacturer's
instructions.
The DC circuit meets the requirements for ungrounded PV
arrays in NEC. Ground fault protection (GFP) is integrated into
the class II double-insulated microinverter.
Enphase Installer Portal monitoring options require an Enphase
IQ Gateway.
The DC and AC connectors have been evaluated and
approved for use as the load-break disconnect required by
NEC 690.
IQ7A-72-2-US Microinverter parameters
DC parameters
10
1x1 ungrounded array; no additional DC side protection required;
© 2023 Enphase Energy Inc. All rights reserved.
Min
Unit
W
V
V
V
V
A
A
AC side protection requires max 20A per branch circuit
enphase.com/en-us/support/module-
Typical Max
Min Typical
295 W – 460+ W
38
18
30
II
September 2023
IOM-00028-1.0
Max
43
58
58
58
15
0