enphase IQ7 Installation And Operation Manual page 36

Topic
Power factor setting
Miscellaneous Parameters
Maximum microinverters per 20A (max) AC branch
6
circuit
240 VAC (single phase)
208 VAC (single phase)
CEC weighted efficiency
240 VAC (single phase)
208 VAC (single phase)
Static MPPT efficiency (weighted, ref EN 50530)
Total harmonic distortion
Ambient temperature range
Night tare loss
Storage temperature range
Features and Specifications
Compatibility
Dimensions not including mounting bracket
Connector type
Weight
Environmental category/UV exposure rating
Torque specifications for fasteners
(Do not over torque)
Cooling
Relative humidity range
Approved for wet locations
Pollution degree
Communication
Standard warranty term
Compliance
6 Limits may vary. Refer to local requirements to define the number of microinverters per branch in your
area.
.
36
IQ7/IQ7+/IQ7X/IQ7A Microinverters Installation and Operation Manual
IQ7PLUS-72-2-US Microinverter parameters
Pairs with most 60-cell/120-half-cell and 72-cell/144-half-cell
PV modules
212 mm x 175 mm x 30.2 mm (approximate)
MC-4 connector
1.08 kg (2.38 lbs.)
NEMA type 6/outdoor
•
•
•
Natural convection - no fans
4% to 100% condensing
Yes
PD3
Power line communication (PLC)
enphase.com/warranty
CA Rule 21 (UL 1741-SA) UL 62109-1, UL1741/IEEE1547, FCC Part 15
Class B, ICES-0003 Class B, CAN/CSA-C22.2 NO. 107.1-01. This
product is UL Listed as PV Rapid Shut Down Equipment and
conforms with NEC-2014 and NEC-2017 section 690.12 and C22.1-
2015 Rule 64-218 Rapid Shutdown of PV Systems, for AC and DC
conductors when installed according to manufacturer's
instructions.
© 2023 Enphase Energy Inc. All rights reserved.
Unit Min
%
97.0
96.5
% 99.0
%
°F
-40
mW
°F -40
6 mm (1/4") mounting hardware: 5 N m (45 - 50 in-lbs.)
8 mm (5/16") mounting hardware: 9 N m (80 - 85 in-lbs.)
When using UL 2703 mounting hardware, use the
manufacturer's recommended torque value
Typical Max
1.0
13
11
5
+149
50
+185
September 2023
IOM-00028-1.0