Iq7X-96-2-Us Microinverter Specifications - enphase IQ7 Installation And Operation Manual

Topic
Grounding
Monitoring
Integrated DC disconnect/
Integrated AC disconnect

5.2.3 IQ7X-96-2-US Microinverter specifications

Topic
Commonly used module pairings
Peak power tracking voltage
Operating range
Maximum DC input voltage
Minimum/maximum start voltage
Maximum DC input short circuit current (module Isc)
Overvoltage class DC port
DC Port backfeed under single fault
PV array configuration
Maximum continuous AC output power (-40 to +149°F)
Peak output power
Power factor (adjustable)
Nominal AC output voltage range
240 VAC (single phase)
208 VAC (single phase)
Nominal output current
240 VAC (single phase)
208 VAC (single phase)
Nominal frequency
No enforced DC/AC ratio. See the compatibility calculator at
7
compatibility
Nominal Voltage Range can be extended if required by the utility.
8
37
IQ7/IQ7+/IQ7X/IQ7A Microinverters Installation and Operation Manual
IQ7PLUS-72-2-US Microinverter parameters
The DC circuit meets the requirements for ungrounded PV
arrays in NEC. Ground fault protection (GFP) is integrated into
the class II double-insulated microinverter.
Enphase Installer Portal monitoring options require an Enphase
IQ Gateway.
The DC and AC connectors have been evaluated and
approved for use as the load-break disconnect required by
NEC 690.
IQ7X-96-2-US Microinverter parameters
Unit
DC parameters
7
1x1 ungrounded array; no additional DC side protection required;
AC parameters
8
© 2023 Enphase Energy Inc. All rights reserved.
Unit Min
Min
W
V 53
V 25
V
V 33
A
A
AC side protection requires max 20A per branch circuit
VA
VA
0.85 leading ...0.85 lagging
Vrms 211
Vrms 183
Arms
Arms
Hz
enphase.com/en-us/support/module-
Typical Max
Typical Max
320 W – 460+ W
64
79.5
79.5
79.5
10
II
0
315
320
264
229
1.31
1.51
60
September 2023
IOM-00028-1.0