Conformity And Standards - Reflex Reflexomat Compact RC Series Operating Manual

Annex
12.2

Conformity and standards

EU-Declaration of conformity for the electrical devices in pressure maintenance, make-up and degassing systems
1. This is to certify that the products conform with the most important protection requirements
set forth in the Council Directives on the harmonization of the laws of the member states
relating to electromagnetic compatibility (2014/30/EU).
The following standards were used to evaluate the products: DIN EN 61326 – 1:2013-07
2. This is to certify that the control boxes conform with the most important requirements of the
low voltage directive (2014/35/EU).
The following standards were used to evaluate the products: DIN EN 61010 – 1:2011-07
EU-Declaration of conformity of a pressure equipment (a vessel / an assembly)
This declaration of conformity is issued under the sole responsibility of the manufacturer.
type
Serial no.
Year of manufacture
max. allowable pressure (PS)
Test pressure (PT)
min. / max. allowable temperature (TS)
max. continious operating temperature membrane /
diaphragm
Operating medium
The conformity of the product described above with the
provisions of the applied Directive(s) is demonstrated by
compliance with the following standards / regulations:
Pressure equipment
Fluid group
Conformity assessment acc. to module
Labelling acc. to Directive 2014/68/EU
Safety valve (air side) (category IV)
Certificate-No. of EU Type Approval
Certificate-No. QA System (module D)
Notified Body for certification of QA System
Registration-No. of the Notified Body
Signed for and on behalf of
56 — English
Pressure expansion vessels / pressure maintenance systems:
Reflexomat, Reflexomat Compact
universally applicable in heating, solar and cooling systems
Manufacturer
Reflex Winkelmann GmbH
Gersteinstraße 19
59227 Ahlen - Germany
Telefon: +49 (0)2382 7069 -0
Telefax: +49 (0)2382 7069 -588
E-Mail: info@reflex.de
Reflexomat with Basic controller — 20.06.2017 - Rev. C
DIN EN 61439 – 1:2012-06
BGV A2
Design – Manufacturing – Product Verification
according to name plate of vessel / assembly
according to name plate of vessel / assembly
according to name plate of vessel / assembly
according to name plate of vessel / assembly
according to name plate of vessel
according to name plate of vessel / assembly
according to name plate of vessel / assembly
Water / dry air
Pressure Equipment Directive, prEN 13831:2000 or EN 13831:2007 or
AD 2000 according to name plate of vessel
Assembly article 4 (2) b) consisting of:
Vessel article 4 paragraph (1) a) i) 2. indent (Annex II table 2) with
• accessories article 4 (1) d): membrane (Reflexomat) respectively
diaphragm (Minimat, Reflexomat Compact), system connection and
safety valve (air side) and optionally
• accessories article 4 (1) d): control unit
2
B + D Reflexomat, Reflexomat Compact
CE 0045
Confirmed and signed by the manufacturer of the safety valve according
to the requirements of directive 2014/68/EU.
see annex
07 202 1403 Z 0780/15/D/1045
TÜV Nord Systems GmbH & Co. KG
Große Bahnstraße 31, D - 22525 Hamburg
0045
The object of the declaration described above is in conformity with the
relevant Union harmonisation legislation - Pressure Equipment Directive
2014/68/EU of the European Parliament and of the Council of 15 May
2014.
Ahlen, 19.07.2016
Norbert Hülsmann
Members of the Management
Volker Mauel