R0P7727TH003TRKE General Information Manual
2. Installation
2.1 Host System Connection
To use T-monitor, connect the serial interface connector (CN1) of the T-Engine board with an RS-232C
interface cable (accessory). Figure 2.1 shows the host system connection method. Figure 2.2 shows the
pins of the serial interface connector. Table 2.1 shows the signals of the serial interface connector.
RS-232C interface
cross cable (accessory)
Serial interface connector
(CN1)
T-Engine Board
Figure 2.1 Host System Connection
16
Figure 2.2 Serial Interface Connector Pins
Host system
CN1
10
Installation
1