Table of Contents
Advertisement
Active Lane Keeping Assist
▌Function of Active Lane Keeping Assist
Active Lane Keeping Assist monitors the area in
front of your vehicle by means of the multifunction
camera (
page 263) and can warn you before
/
you leave your lane unintentionally. The system
can guide you back into your lane through a
course-correcting steering intervention and addi-
tionally warns you with vibration pulses in the
steering wheel. Active Lane Keeping Assist is
available in the speed range between 60 km/h
and 200 km/h.
The system can intervene in the following situa-
tions:
Active Lane Keeping Assist detects a lane
R
marking.
One of your front wheels goes over a lane
R
marking.
If you activate the turn signal indicator, a steering
intervention does not occur on the corresponding
side.
If you leave the lane without activating the turn
signal indicator, but danger of a collision with a
moving obstacle is detected in your lane, a steer-
ing intervention does not occur.
Vehicles with Blind Spot Assist or Driving Assis-
tance Package: if the system detects an obstacle,
such as another vehicle in the adjacent lane, a
steering intervention will occur regardless of the
turn signal indicator.
In the following situations (country-dependent),
Active Lane Keeping Assist may already react
from a speed of approximately 45 km/h:
If your own vehicle is overtaken by another
R
road user and the danger of a collision is
detected, a lane-correcting steering interven-
tion occurs
If you drive over a detected lane marking, the
R
system warns you with vibration pulses in the
steering wheel.
F232 0017 02
Driving and parking 305
Display
1
will appear in the driver's display and a
warning tone will sound in the following situations:
A steering intervention by Active Lane Keeping
R
Assist lasts longer than approximately ten sec-
onds.
The system carries out two or more steering
R
interventions within approximately three
minutes without any steering intervention from
the driver.
In the Active Lane Keeping Assist settings, you
can set the sensitivity of the system and set the
level of support. Additionally, you can set whether
the system should react to discontinuous lane
Advertisement
Table of Contents
