Table of Contents
Advertisement
& WARNING Risk of accident when the
dipped beam is switched off in poor visi-
bility
When the light switch is set to Ã, the
dipped beam may not be switched on auto-
matically if there is fog, snow or other causes
of poor visibility such as spray.
In such cases, turn the light switch to
#
L.
The automatic driving lights are only an aid. You
are responsible for the vehicle lighting.
▌Switching the rear fog light on/off
Requirements
The light switch is in the L or à posi-
R
tion.
Press button R.
#
Please observe the country-specific laws on the
use of rear fog lamps.
Operating the combination switch for the lights
1
High beam
2
Turn signal light, right
3
Headlamp flashing
4
Turn signal light, left
Use the combination switch to select the
#
desired function.
F232 0017 02
Light and sight 193
Switching on high beam
Turn the light switch to the L or Ã
#
position.
Push the combination switch in the direction
#
of arrow 1.
When high beam is activated, the indicator
lamp for low beam L will be deactivated
and replaced by the indicator lamp for high
beam K.
Switching off high beam
Push the combination switch in the direction
#
1
of arrow
or pull it in the direction of arrow
3.
Headlamp flashing
Pull the combination switch in the direction of
#
arrow 3.
Turn signal light
To indicate briefly: push the combination
#
switch briefly to the point of resistance in the
direction of arrow
2
or 4.
The corresponding turn signal light will flash
three times.
Advertisement
Table of Contents
