Table of Contents
Advertisement
202 Light and sight
the driver apart from the excluded vehicles. Highly
reflective signs are also illuminated with reduced
brightness.
At speeds below 25 km/h or when there is suffi-
cient street lighting:
Partial high beam and high beam will be
R
switched off automatically.
At speeds greater than 30 km/h:
If no other road users are detected, high beam
R
will switch on automatically.
If other road users are detected, partial high
R
beam will switch on automatically.
%
The system's optical sensor is located behind
the windscreen near the overhead control
panel.
▌Switching Adaptive Highbeam Assist Plus
on/off
& WARNING Risk of accident despite Adap-
tive Highbeam Assist Plus
Adaptive Highbeam Assist Plus does not react
to:
road users without lights, e.g. pedestrians
R
road users with poor lighting, e.g. cyclists
R
road users whose lighting is obstructed,
R
e.g. by a barrier
On very rare occasions, Adaptive Highbeam
Assist Plus may fail to recognise other road
users with their own lighting, or may recognise
them too late.
In these, or in similar situations, the automatic
high beam will not be deactivated or will be
activated despite the presence of other road
users.
Always observe the road and traffic con-
#
ditions carefully and switch off the high
beam in good time.
F232 0017 02
Switching on
Turn the light switch to the à position.
#
Switch on high beam using the combination
#
switch.
If Adaptive Highbeam Assist Plus is activated,
the _ indicator lamp will light up on the
driver's display. When partial high beam or
high beam is active, the corresponding blue
indicator lamp will also light up.
Switching off
Switch off high beam using the combination
#
switch.
Setting low beam
Multimedia system:
©
Settings
Lights
4
5
5
DIGITAL LIGHT
Low beam
5
5
%
For vehicles without DIGITAL LIGHT head-
lamps, low beam can be set in the
menu.
Select
Right-side
traffic,
Left-side traffic
#
Automatic.
Spotlight
or
Advertisement
Table of Contents
