Table of Contents
Advertisement
2.7
ATX Power Control Connectors
(J7 and J1)
2.7.1 ATX feature connector (J7) and soft power
switch connector (J1)
The PCA-6175 can support an advanced soft power switch function if
an ATX power supply is used. To enable the soft power switch
function:
1. Take the specially designed ATX-to-PS/2 power cable out of the
PCA-6175's accessory bag.
2. Connect the 3-pin plug of the cable to J7 (ATX feature connector).
3. Connect the power on/off button to J1. (A momentary type of
button should be used.)
Warnings: 1. Make sure that you unplug your power supply
Important: Be sure that the ATX power supply can take at least
PCA-6175 User's Manual
28
when adding or removing expansion cards or other
system components. Failure to do so may cause
severe damage to both your CPU card and
expansion cards.
2. ATX power supplies may power on if certain
motherboard components or connections are
touched by metallic objects.
a 10 mA load on the 5 V standby lead (5VSB). If not,
you may have difficulty powering on your system.
Advertisement
Table of Contents
