Advantech PCM-9389 Startup Manual

PCM-9389 Intel
SODIMM or on-board SDRAM, PC/104, 18/24-bit LVDS,
VGA, 2 GbEs, 4 COMs, 4 USB, LPC, iManager 2.0
Startup Manual
Packing List
Before you begin installing your card, please make sure that
the following items have been shipped:
1. 1 PCM-9389 SBC
2. 1 Startup Manual
3. 1 Utility CD
4. 1 Mini jumper pack
5. 1 AT power cable
6. 1 SATA cable
7. 1 PS/2 KB/Mouse
8. 1 Audio cable
9. 1 Ethernet cable
10. 2 USB 2 port cables
11. 1 COM3/4 cable
12. 1 COM2 RS-232 cable
13. 1 COM2 RS-422/485 cable
Remark:
ATX power cable is optional accessory
If any of these items are missing or damaged, please con-
tact your distributor or sales representative immediately.
Note 1: For detailed contents of PCM-9389, please refer
to information on the enclosed CD-ROM (in PDF
format).
Note 2: Acrobat Reader is required to view any PDF
file. Acrobat Reader can be downloaded at:
www.adobe.com/Products/acrobat/readstep2.
html (Acrobat is a trademark of Adobe)
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/eplatform
For technical support and service, please visit our
support website at:
http://service.advantech.com.tw/support/
This manual is for the PCM-9389 Series Rev. A1
Part No. 2006938900
Printed in China
Atom N455/D525 3.5" SBC, DDR3
® TM
p/n: 9689000002
p/n: 1700016141
p/n: 1700006291
p/n: 1700060202
p/n: 1700019584
p/n: 1700017863
p/n: 1700018730
p/n: 1701200220
p/n: 1700019414
p/n: 1700019435
p/n: 1700001112
1st Edition
May 2012
Specifications
General
• CPU: Intel
Atom™ Processor N455 1.66 GHz / D525
®
1.8 GHz
• System Chipset: Intel
®
• System Memory:
- SODIMM: N455 for DDR3 667 MHz up to 2 GB,
D525 for DDR3 800 MHz up to 4 GB
- On-board: DDR3 667 MHz 1 GB
• L2 Cache: 512 KB for N455, 1 MB for D525 on die
• BIOS: AMI 16 Mbit Flash BIOS
• Watchdog Timer: Output system reset, programmable
counter from 1-255 min/sec (set by iManager)
• Expansion Interface: PC/104, LPC
• Battery: Lithium 3 V / 210 mAH
Note: How to clear CMOS (Must follow steps below):
1. Turn off system power.
2. Unplug CR battery cable on BH1.
3. Waiting for 15sec or short BH1 pin1-2.
4. Plug battery cable on BH1.
5. Turn on system power.
• Power management: ACPI 3.0, APM
• Serial ATA: Two SATA ports supporting 300 MB/s
• Serial port: One rear I/O for RS-232 and three internal
I/O for two RS-232 & one RS-232/422/485
• PS/2 KB/Mouse: Rear I/O connector
• USB: Four USB 2.0 compliant universal serial bus ports
• Audio: High Definition audio (HD), line-in, line-out, mic-in
• GPIO: 8-bit general purpose Input/Output (5 V tolerance)
CompactFlash Card
®
• Supports one 50-pin socket for CFC type I/II
Display Interface
• Controller: Intel N455/D525, embedded Gen3.5 DX9
• Memory: 224 MB video RAM shared with system
memory
• Resolution:
- VGA: Intel Atom™ N455 up to 1400 x 1050 (SXGA)
®
Intel Atom™ D525 up to 2048 x 1536
®
- LVDS: Single channel 18/24-bit LVDS up to WXGA
1366 x 768
- TTL: 18-bit TTL (Supported by T-P/N)
• Dual Display: VGA+LVDS (if T-P/N with TTL, VGA+TTL
is supported)
PCM-9389 Startup Manual 1
Atom™ N455/D525+ICH8M