Jumper Settings; How To Set Jumpers; Cpu Core Frequency (J5) - Advantech PCA-6175 Manual

Pentium ii processor-based pci/isa-bus cpu card

Table of Contents

1.9

Jumper Settings

This section provides instructions on how to configure your card by

setting jumpers. It also includes the card's default settings and your

options for each jumper.

You configure your card to match the needs of your application by

setting jumpers. A jumper is the simplest kind of electric switch. It

consists of two metal pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect them. To "close" a

jumper you connect the pins with the clip. To "open" a jumper you

remove the clip. Sometimes a jumper consists of a set of three pins,

labeled 1, 2 and 3. In this case you connect either pins 1 and 2, or 2

and 3.

A pair of needle-nose pliers may be useful when setting jumpers.

You must configure your PCA-6175 CPU card to the frequency of

your Intel Pentium

is equpped to use Pentium processors with speeds of 233, 266, 300 and

333 MHz. Configure your PCA-6175 as follows:

Table 1-3: CPU core frequency (J5)

233 MHz

266 MHz

300 MHz

333 MHz

PCA-6175 User's Manual

II processor by setting jumper J5. The PCA-6175

open

closed

open

closed

open

closed

open

closed

open

Table of Contents