Primary (Cn6) And Secondary (Cn7) Ide Connectors; Floppy Drive Connector (Cn13) - Advantech PCA-6175 Manual

Pentium ii processor-based pci/isa-bus cpu card
Table of Contents

Advertisement

2.1
Primary (CN6) and Secondary (CN7) IDE
Connectors
You can attach up to four IDE (Integrated Device Electronics) drives
to the PCA-6175's internal controller. The primary (CN6) and
secondary (CN7) connectors can each accommodate two drives.
Wire number 1 on the cable is red or blue and the other wires are
gray. Connect one end to connector CN6 or CN7 on the CPU card.
Make sure that the red/blue wire corresponds to pin 1 on the
connector (in the upper right hand corner). See Chapter 1 for help
finding the connector.
Unlike floppy drives, IDE hard drives can connect in either position
on the cable. If you install two drives to a single connector, you will
need to set one as the master and one as the slave. You do this by
setting the jumpers on the drives. If you use just one drive per
connector, you should set each drive as the master. See the
documentation that came with your drive for more information.
Connect the first hard drive to the other end of the cable. Wire 1 on
the cable should also connect to pin 1 on the hard drive connector,
which is labeled on the drive circuit board. Check the documentation
that came with the drive for more information.
Connect the second hard drive to the remaining connector (CN7 or
CN6), in the same way as described above.
2.2

Floppy Drive Connector (CN13)

You can attach up to two floppy disk drives to the PCA-6175's
on-board controller. You can use any combination of 5.25"
(360 KB/1.2 MB) and/or 3.5" (720 KB/1.44/2.88 MB) drives.
The card comes with a 34-pin daisy-chain drive connector cable. On
one end of the cable is a 34-pin flat-cable connector. On the other end
are two sets of floppy disk drive connectors. Each set consists of a
34-pin flat-cable connector (usually used for 3.5" drives) and a printed
circuit-board connector (usually used for 5.25" drives). You can use
only one connector in each set. The set on the end (after the twist in
the cable) connects to the A: floppy drive. The set in the middle
connects to the B: floppy drive.
PCA-6175 User's Manual
24

Advertisement

Table of Contents
loading

Table of Contents