Console Bracket - Dryer - Maytag MLE22PD Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove the dryer front panel
(See page 4-20).
2. Remove two 1/4" hex head screws from the
left end of the console bracket.
3. Remove two 1/4" hex head screws from the
right end of the console bracket.
Left End
Two 1/4" Hex
Head Screws
4. Remove the dryer top panel
(See page 4-26).
5. Remove the 1/4" hex head screw from the
left end of the water channel bracket.

COnSOle BraCKeT - DrYer

Right End
Two 1/4" Hex
Head Screws
4-28
6. Remove the 1/4" hex head screw from the
right end of the water channel bracket.
1/4" Hex
Head Screw
Left End
7. Lift and remove the water channel bracket.
8. Remove the 1/4" hex head screw securing
the front end of the control bracket to the
top edge of the console bracket.
1/4" Hex
Head Screw
9. Pull the console bracket forward and lift the
brackets up and place them on top of dryer.
1/4" Hex
Head Screw
Right End
Water Channel
Bracket