Water Inlet Valves - Maytag MLE22PD Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the washer hoses from the hot and
cold water inlet valves.
4. Remove dryer from stack (See page 4-11).
5. Remove the T-20 security screw securing
the water inlet valve to the back of the
washer.
6. Reach inside the washer and twist the
water inlet valve body to align the locking
tabs with the cut-outs in the back panel.
7. Pull the valve out of the hole in the panel
to gain access to the hose clamp and Rast
connector.
8. Squeeze the clamp and move it down the
hose. Pull the hose off the water inlet valve.

WaTer inleT valveS

Water Inlet
Valve Screws
4-51
Inlet Hoses
& Clamps
9. Lift the locking tab and disconnect the Rast
connector.
TeCH Tip: The hot water valve number
1 has the blue connector and connects to
the left inlet of the chemical dispenser. The
cold water valve number 3 on the bottom
has the white connector and connects to
the middle inlet of the chemical dispenser.
The cold water valve number 2 on the top
has the grey connector and connects to the
right inlet of the chemical dispenser. These
valves receive control signals from the CCU
to manage the temperature and tub water
levels for the incoming water.
Hot Water
Valve #1
1 3 2
Locking Tab
Cold Water Cold Water
Valve #2 Valve #3