eleCTrOniC COnTrOl SeTup inSTruCTiOnS
Dryer control fabric
setting buttons
nOTe: After the washer/dryer has been
installed and plugged in, the display will
show "0 MINUTES" on the washer and dryer
portions of the display. After the washer
and dryer doors have been opened and
closed, the display will show the price for
each machine. On washer/dryers set for free
cycles, the display sections will flash "SELECT
CYCLE."
1. PD Models: Insert coins until "SELECT
CYCLE" flashes on the display portion of
washer or dryer that is to be run.
PN Models: Factory set to zero vend price,
and "SELECT CYCLE" flashes on the
display portion of washer or dryer that is to
be run.
PN models converted to PR: A debit card
is required rather than coins. Generation
1 or 2 debit card systems may be used;
but when the Generation 2 debit system
is used, the controls will automatically be
set to Enhanced Debit mode (J. Ed). In
Enhanced Debit mode, the card balance will
also display when a debit card is inserted
into the reader.
BaSiC OperaTiOn
Dryer Display
Washer Display
Display
3-1
2. Door must be closed on the desired
washer/dryer before cycle selection is
made.
3. Press the fabric setting button for the
washer/dryer cycle desired. For washer
cycles, also select the desired wash
temperature. After the cycle is started, the
time will display and count down.
4. If a cycle is interrupted by opening the door
or power loss, "RESELECT CYCLE" will
flash in the display. To restart the washer/
dryer, close door and reselect desired cycle.
nOTe: When set for free vend operation an
ongoing dryer cycle will cancel if the door is
opened.
Washer control fabric
setting buttons