Door Switch - Dryer; Blower Housing Cover - Maytag MLE22PD Service Manual

DOOr SWiTCH - DrYer

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove the dryer front panel
(See page 4-20).
2. Lift the locking tab and disconnect the door
switch wire connector.
3. Squeeze two tabs on the end of the door
switch and push them through the hole from
the back side of the dryer front panel.
Two Tabs
4. Rotate the other end of switch assembly up
and push it through the hole in front panel.
5. Pull the switch and wire connector out from
the front of the panel.

BlOWer HOuSinG COver

1. Remove the control panel bracket
2. Remove the dryer front panel
3. Remove four 1/4" hex head screws
Door Switch
Connector
4. Support the cover when removing the last
5. Pull the cover out and down to remove the
4-21
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
(See page 4-8).
(See page 4-20).
securing the blower housing cover to the
blower housing.
screw.
blower housing cover.
Two 1/4" Hex
Head Screws
Two 1/4" Hex
Head Screws