Radiant Sensor; Ignitor - Maytag MLE22PD Service Manual

raDianT SenSOr

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove the control panel bracket
(See page 4-8).
2. Remove the two wire connectors from the
spade terminals.
nOTe: The spade connectors are on tight
and pulling hard on the wire or connector
without care may pull the radiant sensor
male terminal off the control and render the
radiant sensor useless.
Radiant Sensor
3. Remove the 1/4" hex head screw.
4. Rotate radiant sensor down to release the
tab securing the other side.
1/4" Hex Head
Screw
4-41

iGniTOr

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove the control panel bracket
(See page 4-8).
2. Disconnect wire connector to ignitor.
3. Hold on to bracket and remove the 8mm
(5/16") hex head screw to remove bracket
and ignitor.
Ignitor
8mm Hex
Head Screw
Wire
Connector
4. Remove ignitor from bracket by removing
the 8mm (5/16") hex head screw.
nOTe: Do not touch the dark ignitor end, skin
oil will make a hot spot on the ignitor causing it
to fail prematurely.
nOTe: Take care not to bump or tap the
ignitor. It is extremely brittle.