Belt - Dryer - Maytag MLE22PD Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove the dryer front bulkhead
(See page 4-23).
2. Reach in under the drum and lift the idler
pulley to release tension on the belt.
3. Remove the belt from the motor pulley and
then remove it from the idler pulley.
Motor Pulley
4. Remove the belt from the dryer.
nOTe: The belt is a multi-ribbed belt.

BelT - DrYer

5. The belt can be reinstalled without
6. Reach in under the drum and wrap the belt
Idler Pulley
7. Turn the drum to align the belt travel.
4-25
removing the drum from the dryer.
When reinstalling the belt, make sure the
ribs of the belt are facing the drum.
Back Bulkhead
around the motor pulley. Lift the idler pulley
and wrap the belt around the idler pulley
wheel. Release the idler pulley to apply
tension to the belt.
Idler Pulley
Belt
Motor Pulley