Dryer Installation - Maytag LSE7806ACQ Installation Instructions Manual

DRYER iNSTALLATiON
Vent Kit - standard - 4" (10.16cm)
kit includes two elbows, three pipes and
one vent hood
Vent Hood- 4" (10.16cm) opening
Aluminum Pipe - 4" x 24" (10.16cm x 60.96cm
Aluminum Elbow - 4" (10.16cm)
Aluminum Window Plate - 15"x 20"
(38.10cm x 50.80cm) - 4" (10.16cm)
Flexible Vent Kit - contains wide opening vent
hood, wall plate, two clamps and flexible
aluminum vent duct
Flexible Aluminum Vent Duct - 4" (10.16cm)
diameter - 38" (81.28cm) length stretches
to 8' (2.44m)
Clamp for Flexible Aluminum Duct
Exhaust Deflector Kit -inside exhaust kit
Natural to LPG Conversion Kit for Gas Valve
Dacron Lint Bag
Grounding Kit - contains ground wire, clamp,
ground screw and washer
(Part No. 12001875)
iNSTALL WASHER UNiT
1, Remove top cover
shipping pads
taped to washer
top.
m
Remove fill "t,
hoses.
Replace and
leave tub
block in place \--
until installation is
complete. Close rid.
3, Remove the crate ,_"---_%\
base wires from
orate b ase. Use
pliers or screw- _-'f /
driver to pry from "_F-- _1-![_ .... I[!
wood. Discard crate I i/_ Ill I
base
4, Run washer rear legs all the way up into
the rear corner brackets. Lock in place by
tightening lock nuts up against base.
Leave front legs loose for leveling later.
install the vinyl feet on the front washer legs.
m
m
Move the washer into position in front of
the dryer and stand. Use caution to avoid
floor damage because of the minimum
height of the rear legs.
NOTE: Before sliding washer back into
position, connect fill hoses and insert drain
hose in standpipe.
tnstall inlet hoses.
Run water through both water _._<x:_
faucets into a bucket to purge /_.o_S'_' _
the water line particles that __
might clog the hoses. While /,_ /,.(
running water through the _/_\\
faucets, determine which _', l\i ,_
faucet is HOT water and _. ..... S
place an identifying mark \\ " '
on it. Traditionally the HOT water faucet is
on the left.
insert one screen and
then one washer into the
faucet ends of the inlet
hoses (straight end of
hoses). The screens
t I
should be pointing @ @--wAsaE.
I
out to fit properly.
I I
10 printed in U,S,A,