Front Panel - Dryer - Maytag MLE22PD Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Open dryer console cover (See page 4-17).
2. Remove the control panel bracket
(See page 4-8).
3. Open dryer door and remove the lint filter.
4. Remove three Phillips head screws, below
door opening, securing the front panel to the
blower housing cover. These screws are
large pan head screws.
3 Phillips Head Screws
5. The center screw has a plastic bumper that
will come off with the screw.
6. Lift the locking tab and disconnect the door
switch wire connector.

FrOnT panel - DrYer

4-20
nOTe: The door switch wire connector has
three wires going to the door switch, and
two wires going to the control board. The
third wire would be for a cavity light, but
commercial dryers do not come with one.
Door Switch
Wire Connector
7. Remove two 1/4" hex head screws securing
the bottom of front panel to dryer. These
screws were hidden behind the control
panel.
Two 1/4" Hex
Head Screws
8. Remove two 1/4" hex head screws securing
the top of the front panel to the dryer.
These screws were hidden behind the dryer
console panel. Make sure to support the
front panel when removing the screws so it
does not fall.
Two 1/4" Hex
Head Screws
9. It may be necessary to loosen the bottom
two 1/4" hex head screws securing the dryer
control panel bracket to the side panels.
10. Pull the dryer front panel away from the
dryer and remove the panel.