Page 1
COMMERCIAL GAS AND ELECTRIC STACKED WASHER / DRYER INSTALLATION INSTRUCTIONS MODELS MLG19PD, MLE19PD The installation, including a proper exhaust system, is the responsibility of the owner. LEAVE THESE INSTRUCTIONS WITH THE OWNER 2202407 Printed in U.S.A.
For Australia the installation should also be carried out in accordance with the AGA Installation Code for gas burning appliances. Maytag gas dryers have been certified for operation on either Natural Gas or LP Gas (with appropriate conversion).
2. Space requirements The washer / dryer dimensions are shown in the figure below: " 69.9 cm 5" Location " Location 12.7 cm of Canadian 14 cm of Canadian terminal terminal block block " (electric (gas 1.6 cm models) Dryer models) Location of dryer terminal "...
IMPORTANT: This appliance is not IPX4 (splashproof) rated. It must not be installed or stored in an area where it will be exposed to water. Do not use a water hose or wet cloth to clean the outside of the appliance. For best performance, the appliance must be installed on a solidly constructed floor.
Washer Door: 1. Swing door fully open and remove the two screws securing the hinges to the front panel. 2. Lift door slightly and pull door out of plastic front shroud. Press the plastic shroud toward the cabinet, should the hinge bind. Set the door aside. 3.
The exhaust duct should end with an exhaust hood with a swing-out flap to prevent back-draughts and access for wildlife (see Accessories). Never use an exhaust hood with a magnetic flap. The hood should have at least 300mm (12”) clearance between the bottom of the hood and the ground or other obstruction.
NOTE: In accordance with the European EMC Directive (89/336/EEC) the maximum electricity supply system impedance to which the electric dryer/washer should be Ω Ω connected is declared to be 0.247 + J0.155 Some local wiring regulations require connection of an additional earth bond connection to the appliance.
12. Final installation checklist Instructions and Installation Kit have been removed from inside. Shipping straps have been removed. Appliance has been properly levelled. All legs should be firmly on the floor and lock nuts MUST be tightened. Water is turned on and checked for leaks at tap and water valve connections. Appliance is connected to electricity supply and is properly earthed.