ABB RELION 670 Series Applications Manual page 334

Section 12
Control
12.10 Single command, 16 signals SINGLECMD
12.10.1 Identification
Function description
Single command, 16 signals
12.10.2 Application
Single command, 16 signals (SINGLECMD) is a common function and always included in the IED.
The IEDs may be provided with a function to receive commands either from a substation
automation system or from the local HMI. That receiving function block has outputs that can be
used, for example, to control high voltage apparatuses in switchyards. For local control functions,
the local HMI can also be used. Together with the configuration logic circuits, the user can govern
pulses or steady output signals for control purposes within the IED or via binary outputs.
Figure 168
configuration logic circuit to control a high-voltage apparatus. This type of command control is
normally carried out by sending a pulse to the binary outputs of the IED. Figure
operation. An open breaker operation is performed in a similar way but without the synchro-check
condition.
Close CB1
ANSI04000206 V2 EN-US
Figure 168: Application example showing a logic diagram for control of a circuit breaker via
Figure 169
Disabled signals. Here, the output is used to control built-in functions or external devices.
328
IEC 61850
identification
shows an application example of how the user can connect SINGLECMD via
Single
command
function
SINGLECMD
CMDOUTy
OUTy
User-
defined
conditions
Synchro-
check
configuration logic circuits
and figure 170 show other ways to control functions, which require steady Enabled/
IEC 60617
identification
SINGLECMD -
Configuration logic circuits
AND
en04000206_ansi.vsd
1MRK 505 337-UUS A
GUID-2217CCC2-5581-407F-A4BC-266CD6808984 v1
ANSI/IEEE C37.2
device number
-
168 shows a close
Application manual
SEMOD119849-1 v2
M12445-3 v3