ABB RELION 670 Series Applications Manual page 332

Section 12
Control
When the input signal VALID is active, the values of the OPEN and CLOSE inputs determine the
two-bit integer value of the output POSITION. The timestamp of the output POSITION will have the
latest updated timestamp of the inputs OPEN and CLOSE.
When the input signal VALID is inactive, DPGAPC function forces the position to intermediated
state.
When the value of the input signal VALID changes, the timestamp of the output POSITION will be
updated as the time when DPGAPC function detects the change.
Refer to Table
quality attributes.
Table 41:
VALID
0
1
1
1
1
12.7.3 Setting guidelines
The function does not have any parameters available in the local HMI or PCM600.
12.8 Single point generic control 8 signals SPC8GAPC
12.8.1 Identification
Function description
Single point generic control 8 signals
12.8.2 Application
The Single point generic control 8 signals (SPC8GAPC) function block is a collection of 8 single
point commands, designed to bring in commands from REMOTE (SCADA) to those parts of the
logic configuration that do not need complicated function blocks that have the capability to
receive commands (for example SCSWI). In this way, simple commands can be sent directly to the
IED outputs, without confirmation. Confirmation (status) of the result of the commands is
supposed to be achieved by other means, such as binary inputs and SPGGIO function blocks.
326
41 for the description of the input-output relationship in terms of the value and the
Description of the input-output relationship
OPEN
-
0
1
0
1
CLOSE
-
0
0
1
1
IEC 61850 IEC 60617
identification identification
SPC8GAPC -
1MRK 505 337-UUS A
POSITION
Value Description
0 Intermediate
0 Intermediate
1 Open
2 Closed
3 Bad State
ANSI/IEEE C37.2
device number
-
Application manual
SEMOD55398-5 v4
SEMOD176448-1 v3
SEMOD176456-2 v3
SEMOD176511-4 v4