NEC EXP805 User Manual page 213
Hide thumbs
Also See for EXP805:
- Maintenance manual (136 pages) ,
- User manual (262 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
Chapter 2 Preparations
(b) Removal procedure
Remove the server from the rack in the following procedure.
Make sure that the server is turned off and then disconnect the power cord or all interface cables from
the server.
Remove the front bezel.
Open the lids of the unit fixing screws on both sides of the device. Then remove the fixing screws
inside with Hexalobular screwdriver, if the device is screwed on. If the device is not screwed on, you
can unlock the device just by opening the lid.
Slide the unit forward, and remove from the rack while holding it securely. In case the unit is locked in
the middle, continue pushing the rail stopper on the side of the rail and slowly draw out the unit to
remove from the rack.
Important
At least two persons are required to remove the server from rack.
Important
Be careful not to get your fingers caught in the rails or lever.
Express5800/R120h-2M (2nd-Gen) User's Guide
2. Installation and Connection
213
Advertisement
Table of Contents
