Installing Tertiary Riser Card - NEC EXP805 User Manual

Chapter 2 Preparations
4. See Chapter 2 (1.33 Attaching the air baffle) to attach the top cover of the server.
5. Please see Chapter 2 (2 Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON.

Installing Tertiary Riser Card

Please prepare the following before installing the options.

Parts included in the option kit

T-10 hexalobular driver
To install the components, follow these steps.
1. See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2. If the secondary riser card is not attached, proceed to step 5. If it is attached, raise the screw handles at
the top of riser card, turn them to the left 180 degrees, and then pull up the riser card to remove the riser
card.
92
Note In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Note In order to prevent the damage to server's main body or the expansion board,
please remove all the AC power cables before removing/installing riser card.
Express5800/R120h-2M (2nd-Gen) User's Guide
1. Installing Internal Optional Devices