NEC EXP805 User Manual page 27

Chapter 1 General Description
・12 x 3.5-inch drive model
(12)-1
(12)-1
(12)-1
(1) Expansion Bay
Used for installing the optional hard disk drive,
universal media bay
(2) 2.5-inch Hard Disk Drive Bay
Bays for installing HDDs. The sequential numbers
indicate the corresponding bay numbers. All bays
include Dummy Trays.
(3) POWER Switch/LED
A switch for turning on/off the server. Press once to
turn on the server. POWER LED lights when it is on.
Press it again to turn off the server. Hold down the
switch for four seconds or more to forcibly turn off the
server.
(4) STATUS LED
LEDs for showing the server status
(5) LAN LINK/ACT LED
LEDs for showing the status of accessing to the
network.
(6) UID (unit ID) switch/LED
The switch to turn ON/OFF unit ID LED or restart iLO.
When pressed once, the UID LED lights up, and it
turns ON. Press it again to turn it OFF.
For instructions on restarting iLO using the UID
switch, see iLO 5 User's Guide.
During executing commands from software, remote
management of iLO or firmware update, the UID
LED lights up or flashes if iLO is restarted via UID
switch
(7) iLO service port USB connector
A USB connector used for connecting to iLO
such as for acquiring log. For details, refer to
iLO 5 User's Guide.
(12)-2 (12)-3
(12)-2
(12)-2
Important Do not reboot the iLO from the boot of the server until the completion of the
OS boot.
Additionally, do not reboot the iLO during using the System Utilities.
Express5800/R120h-2M (2nd-Gen) User's Guide
(12)-4
(12)-3 (12)-4
(12)-3
(12)-4
(8) USB3.0 connector (front)
Connectors for connecting USB 3.0 interface
devices.
(9) Pull-out Tab
A tab for showing the model number and serial number
of the server
(10) 2.5-inch Expansion Bay (option)
Used for installing 2 x 2.5-inch expansion modules
(optional).
(11) Optical disk drive (option)
Attaching the optical disk drive.
According to the order at the time of buying, one of the
following option drives is installed.
－ DVD-ROM drive
－ DVD Super MULTI drive
(12) 3.5-inch Hard Disk Drive Bay
Bays for installing HDDs. The sequential numbers
indicate the corresponding bay numbers. All bays
include Dummy Trays.
(13) Display Port Connector (Optional)
Not support
(14) USB 2.0 connector (optional)
Connectors for connecting USB 2.0 interface devices.
4. Names and Functions of Parts
(9) (5)
(3)
(4)
(6)
27