Emptying The Hole Punch Waste Container (For C3 Finisher Or C3 Finisher With Booklet Maker) - Fuji Xerox ApeosPort-VI C7771 Quick Reference

5 Maintenance
4
Empty the container.
5
Insert the emptied hole punch waste container
into the finisher until it stops.
6
Close the front transport cover, and then close
the top transport cover of the finisher.
Note
5
Emptying the Hole Punch Waste Container
(for C3 Finisher or C3 Finisher with Booklet Maker)
When the C3 Finisher (optional) or the C3 Finisher with Booklet Maker (optional) is installed
and the hole punch waste container becomes full, a message appears on the touch screen.
When the message appears, empty the hole punch waste container as instructed.
Important • Empty the hole punch waste container when the machine is on. If you empty the container while the
1
Make sure that the machine is not operating,
and open the finisher front door.
104
• If the cover is not completely closed, a message will appear and the machine remain paused.
machine is off, the machine does not recognize that the container has been emptied.
• Empty the hole punch waste container after the message appears. Otherwise, the machine cannot
recognize the correct remaining amount of the punch scraps.
• Make sure to discard all paper chads when emptying the hole punch waste container. Not doing so
will cause the container to fill up before the message telling you to empty the container appears
again, and this can cause machine malfunction.
• When the machine is in Power Saver mode, exit Power Saver mode by pressing the <Power Saver>
button on the control panel before you empty the punch waste container.
• Before emptying the punch waste container, press the <Machine Status> button and check the
current status for the punch waste container even when the control panel is lit.