Operating The Cs1-500; Site Of Work; Cutting Method - Norton clipper CS1-500 P13 Operating Instructions Manual

VERS.2022.10.20

4 OPERATING THE CS1-500

4.1 Site of work

Before you start working, please check the following points:

Remove from the site anything, which might hinder the working procedure.

Make sure the site is sufficiently well lit.

Make sure you have a continual adequate view of the working area so you can intervene in
the working process at any time.

Keep other staff out of the area, so you can work securely.

4.2 Cutting method

In this section, you can find instructions to make a straight cut at the desired depth.
4.2.1 Preparing your cut
Before starting the machine,

Draw a line on the floor over the cutting length.

Make sure you have filled the engine tank with fuel, and the water tank with water. No petrol
is supplied with the machine.

The engine is shipped with oil. Check oil level before starting. Top up if required.

Make sure you have mounted the correct blade as recommended by the manufacturer
depending on the material to be worked, the working procedure (dry or wet cut) to be carried
out, and the efficiency required.

Make sure that the flanges securely hold the diamond blade.

Make sure that the blade is not touching the floor before starting.

Roll the machine until the blade is over the line.

Lower the guide-a-cut so it touches the line.
4.2.2 Cutting the floor
You can now start the engine.
To make your cut,
You can now start the engine. To make your cut,

Turn on the water tap according to the type of blade used and the cut required:
o Water cutting: a sufficient amount of water should be used continuously throughout
the cutting process to cool the disc properly.
o Dry cutting: if possible, a small amount of water should be used to limit the creation of
dust.

Turn the depth hand wheel until the blade slightly touches the floor.

Turn the hand wheel to lower blade into the cut.

Once the required depth of cut is reached, push the machine forward with steady and gentle
pressure and follow the line with the pointer. The feed speed must be adjusted depending on
the material being cut, and depth of cut.

At the finish of the cut, raise the blade out of the cut by turning the hand wheel, switch off the
engine and shut-off the water.
CS1-500_MAN_EN
17