Table of Contents
Advertisement
Line Voltage Conversion
WARNING:
Shock Hazard. Operating personnel must not remove instrument covers.
Component replacement and internal adjustments must be made only by qualified
service personnel.
Open the Unit
♦
Turn off ac power and disconnect the power cord from the unit.
♦
Loosen the two screws on the rear bezel and remove the bezel (use a #15 Torx drive).
Remove the two screws on the bottom of the unit (use a #15 Torx drive).
♦
Pull the cover back to remove it from the unit.
♦
Configure the Power Transformer
Locate the ac input wiring harness on the left side of the transformer
♦
Use a needle nose pliers and connect the ac input wiring harness according to the information in the
♦
following figure:
E
147
Advertisement
Table of Contents
