Calibrate:data; Calibrate:level; Calibrate:password; Calibrate:save - Agilent Technologies 66311A User Manual

Table of Contents

CALibrate:DATA

This command enters a calibration value that you obtain by reading an external meter. You must first

select a calibration level (with CALibrate:LEVel) for the value being entered.

Command Syntax CALibrate:DATA<NRf>

Parameters <external reading>

Examples CAL:DATA 3222.3 MA

Related Commands CAL:STAT

This command selects the next point in the calibration sequence.

P1: the first calibration point

P2: the second calibration point

Command Syntax CALibrate:LEVel <point>

Parameters P1 | P2

Examples CAL:LEV P2

This command lets you change the calibration password. A new password is automatically stored in

nonvolatile memory and does not have to be stored with CALibrate:SAVE.

If the password is set to 0, password protection is removed and the ability to enter the calibration mode is

unrestricted.

Command Syntax CALibrate:PASScode<NRf>

Parameters <model number> (default)

Examples CAL:PASS 6812

Related Commands CAL:SAV

This command saves any new calibration constants after a calibration procedure has been completed in

nonvolatile memory. If CALibrate:STATe OFF is programmed without a CALibrate:SAVE, the previous

calibration constants are restored..

Command Syntax CALibrate:SAVE

Parameters None

Examples CAL:SAVE

Related Commands CAL:PASS

Unit A (amperes)

CAL:LEV

CAL:STAT

Language Dictionary - 8

CAL:DATA 5.000

CAL:PASS 6.1994

Table of Contents