Output:ri:mode; Output:type - Agilent Technologies 66311A User Manual

8 – Language Dictionary

OUTPut:RI:MODE

This command selects the mode of operation of the Remote Inhibit protection. The RI mode is stored in
non-volatile memory. The following modes can be selected:
LATChing causes a TTL low signal on the INH input to disable the output. The only way to
clear the latch is by sending OUTPut:PROTection:CLEAR while the INH input is
false.
LIVE allows the INH input to disable the output in a non-latching manner. In other words,
the output follows the state of the INH input. When INH is low true, the output is
disabled. When INH is high the output is not affected.
the INH input is disabled.
OFF
Command Syntax OUTPut:RI:MODE <mode>
Parameters LATChing | LIVE | OFF
Examples OUTP:RI:MODE LIVE
Query Syntax OUTPut:RI:MODE?
Returned Parameters <CRD>
Related Commands OUTP:PROT:CLE

OUTPut:TYPE

This command programs the output compensation circuit. This circuit compensates the output of the dc
source according to the input capacitance of the phone being tested. The circuit covers the following
capacitance ranges:
LOW mode: 0 µF to 12,000 µF
HIGH mode: 5 µF to 12,000 µF
The HP 66311A is shipped with the output compensation set LOW mode. This mode provides the stable
operation for all types of phones. The HIGH mode setting provides better transient response performance
for phones that have input capacitances greater than 5 µF. In this mode however, the operation of the dc
source will be unstable when connected to phones that have input capacitances less than 5 µF. (Units
with option J01 are shipped with the compensation set to HIGH. The *RST value is also HIGH.)
NOTE: If you set the output compensation to HIGH mode and you want the unit to power up in
HIGH mode, you must first save the desired output settings in non-volatile memory
location 0 with the *SAV command. Then program the dc source to power up with the
settings stored in memory location 0 with the OUTP:PON:STAT RCL0 command.
Command Syntax OUTPut:TYPE[:CAPacitance] <setting>
Parameters HIGH | LOW
*RST Value LOW
Examples OUTP:COMP HIGH
Query Syntax OUTPput:TYPE[:CAPacitance]?
Returned Parameters 0 | 1
96