Table of Contents
Advertisement
11.4 ENGINE
(1). While engine is still warm, drain oil from crankcase. Refill with the
recommended new oil.
(2). Remove spark plug and pour about 15ml (1/2 ounce) of engine oil
into the cylinder through spark plug hole on the engine cylinder head,
and cover spark plug hole with rag. Pull the starting rope several times
to coat the cylinder walls with engine oil.
(3). Install and tighten the spark plug.
(4). Pull the Starter Grip until you feel compression, and then stop
pulling. (This prevents the cylinder and valves from rusting)
(5). Clean the generator outer surfaces. Check that cooling air slots
and openings on generator are open and unobstructed.
(6). Store the unit in a clean, dry place. If possible, store the unit
indoors and cover it to give protection from dust and dirt.
- 64 -
Advertisement
Table of Contents
