Energizer EZG2000iUK User Manual page 28

Table of Contents

Advertisement

Add Engine Oil:
(1). Open the Oil Maintenance Cover 1, and remove the Oil Cap 2.
(2). Fill the specified amount of the recommended engine oil, and then
install and tighten the Oil Cap.
NOTE
Make certain the generator is on a flat, level surface.
Keep the engine oil level between LOWER LIMIT and UPPER
LIMIT. Too much or too little oil will shorten the service life of
the engine.
UPPER LIMIT
LOWER LIMIT
The engine is equipped with a low oil sensor that will prevent
the engine from running. If the oil level falls below a critical
threshold, the engine will stop automatically.
When the engine shuts down automatically by the low oil
protection, the LOW OIL LEVEL LED (yellow) will come on,
and unless you refill with oil, the engine will not start again.
2
2
1
Loosen
- 28 -

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ezg series

Table of Contents